Sbus<N>:Flexray:channel - Agilent Technologies InfiniiVision 3000 Programmer's Manual

:SBUS<n>:FLEXray:CHANnel
Command Syntax
:SBUS<n>:FLEXray:CHANnel <channel>
<channel> ::= {A | B}
The :SBUS<n>:FLEXray:CHANnel command specifies the bus channel, A or
B, of the FlexRay signal.
Query Syntax
:SBUS<n>:FLEXray:CHANnel?
The :SBUS<n>:FLEXray:CHANnel? query returns the current bus channel
setting.
Return Format
<channel><NL>
<channel> ::= {A | B}
See Also
•
•
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
(see page 1088)
"Introduction to :TRIGger Commands"
":SBUS<n>:FLEXray Commands"
:SBUS<n> Commands
on page 843
on page 635
26
639