Handlebar Adjustment - Polaris 600 EDGE Touring 121 Owner's Manual

Handlebar Adjustment

Standard Handlebars
Follow these steps to adjust the handlebars for a personal fit.
1. Remove the handlebar cover to
expose the handlebar and the four
adjuster block bolts (A).
2. Using a 7/16" (11 mm) wrench,
loosen the four nuts on the bottom of
the adjuster block (turn handlebar to
left or right for access to back nuts).
NOTE: It may be necessary to pry the
adjuster blocks apart with a screw driver.
3. Adjust the handlebar to the desired height. Be sure handlebars, brake
lever and throttle lever operate smoothly and do not hit the gas tank,
windshield or any other part of the machine when turned fully to the
left or right.
4. Torque the handlebar adjuster block bolts to 11-13 ft. lbs. (15-17.6
Nm).
5. Replace the handlebar cover.
THE PERFECT FIT
A
53