Kawai Novus NV10 Owner's Manual page 150

Assembly Instructions
1. Attaching the legs to the pedal base
Place the pedal base (D) on a flat floor. Check that there are
no musical scores or parts on the floor, and ensure that the
pedal support bolt is attached.
Loosely attach the left leg (B) to the pedal base (D) using 4
screws .
Press the metal fitting plate of the left leg firmly against the
pedal base, and ensure that the base makes firm contact
with the floor, then tighten the four screws.
Attach the right leg (C) to the pedal base using the 4
remaining screws , in the same way as step 1- .
Ensure that the assembled pedal base and legs are
absolutely stable and do not rattle when pushed. If the
stand is not completely steady, loosen the screws attached
in the previous steps, gently reposition the parts, and then
retighten the screws.
Pedal support bolt
D
150
D
B
2. Removing the main unit from the box
Check that the main unit box is facing upward, then open
the upper side of the box.
Cut the four sides of the box, and open them out fully.
Be careful not to injure hands or fingers when
cutting the box.
Remove the corrugated boards (side, upper side),
polystyrene foam (upper side), and any remaining packaging
material, to allow the main body (A) to be lifted.
A