Playing A Song With Dvs; Functions Available When Using Dvs - Roland DJ-505 Owner's Manual

* If the calibration deck is not shown, go to the SETUP screen's
"EXPANSION PACKS" tab, select [Vinyl/CDJ Control], and make sure that
there is a check mark on "Enable Vinyl/CDJ control. "
* If the green circle is not shown on the scope, check the following items.
5 The turntable/DJ player is correctly connected with the DJ-505.
5 The ground wire of the turntable is connected to the DJ-505's
PHONO GROUND terminal.
5
Make adjustments so that the green circle is a perfect circle.
L/R Balance
Compensates for distortion in the vertical direction.
P/A Balance Compensates for distortion in the horizontal direction.
Zoom Enlarges the circle in the scope.
Noise Sensitivity If the control signal is below the value specified here, it is treated as noise.
With the needle placed on the record of the stopped turntable, or with the
Estimate DJ player paused or stopped, holding down this button moves the "Noise
Sensitivity. "
* For details, refer to the Serato DJ owner's manual.
6
Repeat steps 1–5 to adjust the control signal of all turntables or
DJ players.

Playing a Song with DVS

1
In the virtual deck screen, click the VINYL control mode button
to select either REL mode or ABS mode.
2
Import a song as described in "Importing a Song" (p. 11).
3
Load the song as described in "Loading a Song" (p. 11).
4
Operate your turntable or DJ player to play back the control
record or CD.
The song that's loaded into the deck plays.
5
Move the channel fader upward and turn the [TRIM] knob
toward the right to adjust the volume.
Adjust the volume so that the channel level indicator's OVER segment
does not light.
6
Turn the [MASTER LEVEL] knob toward the right to adjust the
level of the speakers.

Functions Available When Using DVS

When using DVS, the available functions are limited as follows.
Function
Hot cue
Roll
Slicer
Slicer loop
Performance pads
Sampler
Velocity sampler
Cue loop
Saved loop
Saved flip
Loop
Loop active
Loop half/double/shift
Loop in
Loop Loop slot select
4 beat loop
Loop out
Re-loop
Loop exit
Play/Pause/Stutter
Transpose Temporary cue
Sync
Scratch
Jog dial Pitch bend
Skip
Tempo slider
Key lock
Tempo control
Tempo reset
Tempo range
Flip rec
Flip loop
Flip start
Flip
Flip on/off
Flip slot select
Flip save
Censor
Others Reverse play
Rec
(*1) Only hot cue settings are possible. Recall is not possible.
Using Serato DVS
REL mode ABS mode
(
(*1)
(
(
(
( (
( (
(
(
(
(
(
(
(
(
(
(
(
(
(
(
(
(
( (
(
(
(
(
(
(
(
29