Flip Display In The Serato Dj Screen - Roland DJ-505 Owner's Manual

Using Serato Flip
* If "Flip" is not shown, double-click the [MY PRODUCTS] tab in the my
serato screen, and check whether "Serato Flip" is activated.
If the following screen appears, click [ACTIVATE].
5
Make sure that "Enable Serato Flip" has a check mark.
If it does not have a check mark, add a check mark.
6
Close Serato DJ.
7
Turn off the power of the DJ-505, wait about one minute, and
then turn the power on again.
8
Restart Serato DJ.
* After you activate Serato Flip, you must restart Serato DJ. If you don't
restart, Serato DJ might not respond when you operate the DJ-505.
24

Flip Display in the Serato DJ Screen

Virtual deck screen
1 2 3 4
1
Flip tab
2
Flip play/trigger
3
Flip start time
4
Flip slot on/off
5
Flip slot loop
6
Flip slot delete
Serato DJ Flip panel
7 8 9
7
Flip record
8
Flip play
9
Flip on/off
10
Flip loop
11
Flip save
12
Flip loop snap
5 6
Use this to see the Flip slots.
Use these to turn on the Flip that you want to
recall, and play from the beginning of the Flip.
Each Flip slot shows the start time of the Flip.
When Flip is on, the Flip starts playing when the
song reaches this time.
* You can double-click to assign a name to the
Flip.
Turns the Flip on/off.
Even if Flip is on, Flip playback does not start until
the song reaches the Flip start time.
If this is highlighted, the Flip plays as a loop.
Deletes the Flip.
10 11 12
Puts the Flip in a record-ready state.
Even if Flip record is on, Flip recording does not
start immediately.
Flip recording starts when playback is started by
hot cue after Flip record is turned on.
To end Flip recording, turn Flip record off.
Turns Flip on, and starts playback from the
beginning of the Flip.
If the Flip is currently playing, return to the
beginning of the Flip.
Turns the Flip on/off.
Even if Flip is on, Flip playback does not start until
the song reaches the Flip start time.
If this is highlighted, the Flip plays as a loop.
Saves the recorded Flip in the Flip slot.
If this is highlighted, the Flip end point is
automatically adjusted to match the beat location.