Advertisement
Install Batteries
NOTE: Install all batteries in both units within a 6 minute period to ensure proper
wireless functionality. Always install batteries into the wireless sensor FIRST.
Wireless Sensor - 4 "AA" Batteries Required
GENTLY SQUEEZE OUTER
1
CASING AND PULL INNER
INSTRUMENT POD OUT
SQUEEZE
SQUEEZE
PULL
SET THE OUTER CASING
2
ASIDE, TAKE CARE THAT IT
IS NOT DROPPED
5
REPLACE BATTERY
COMPARTMENT COVER
(not included)
REMOVE BATTERY
3
COMPARTMENT COVER
NOTE: A/B/C SWITCH SELECTION MUST
MATCH MAIN UNIT A/B/C SELECTION
REMOVE
BATTERY
DOOR
INSERT 4 FRESH "AA"
BATTERIES AND REPLACE
4
BATTERY COMPARTMENT
COVER.
RE-INSTALL INNER
6
INSTRUMENT POD UNTIL
TABS ALIGN AND YOU
YOU HEAR A "CLICK"
INSERT
- 4 -
Install Batteries
NOTE: Install all batteries in both units within a 6 minute period to ensure proper
wireless functionality. Always install batteries into the wireless sensor FIRST.
Main Unit - 3 "AA" Batteries Required
REMOVE BATTERY
1
COMPARTMENT COVER
REMOVE
BATTERY
DOOR
NOTE: A/B/C SWITCH SELECTION
MUST MATCH WIRELESS SENSOR
A/B/C SELECTION
INSERT 3 FRESH "AA"
2
BATTERIES
PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY SAFE WAY
AND IN ACCORDANCE WITH YOUR LOCAL LAWS AND REGULATIONS.
BATTERY SAFETY:
Clean the battery contacts and also those of the device prior to battery
installation. Remove batteries from equipment which is not to be used for an extended period of
time. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead
batteries from the device. Dispose of used batteries properly. Only batteries of the same or
equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT
dispose of batteries in fire, as batteries may explode or leak. DO NOT mix old and new batteries or
types of batteries (alkaline/standard). DO NOT use rechargeable batteries. DO NOT recharge
non-rechargeable batteries. DO NOT short-circuit the supply terminals.
(not included)
REPLACE BATTERY
3
COMPARTMENT COVER
- 5 -
Advertisement
