Setup; Install Or Replace Batteries - ACU-RITE 00875 Instruction Manual

Digital rain gauge with wireless self-emptying rain collector

Hide thumbs

Table of Contents

SETUP

Install or Replace Batteries

AcuRite recommends high quality alkaline batteries for the best product

performance. Heavy duty or rechargeable batteries are not recommended.

SQUEEZE

Rain Collector

SQUEEZE

LARGE

TABS

1. Separate rain collector cover from the base by gently

squeezing tabs and pulling the cover upwards.

SQUEEZE

LARGE

TABS

2. Remove battery box by squeezing the two tabs on

each end together.

3. Remove and discard foam rain gauge stabilizer.

4. Insert 2 x AA batteries into the battery compartment

as shown. Follow the polarity (+/-) diagram in the

battery compartment.

5. Securely place the battery box back into the rain col-

lector base.

6. Securely re-attach the rain collector cover onto rain

collector base.

PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY SAFE

WAY AND IN ACCORDANCE WITH YOUR LOCAL LAWS AND REGULATIONS.

BATTERY SAFETY: Clean the battery contacts and also those of the device prior to battery installation. Remove batteries from equipment which is not to

be used for an extended period of time. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the device. Dispose of

used batteries properly. Only batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries

in fire, as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (alkaline/standard). DO NOT use rechargeable batteries. DO NOT

recharge non-rechargeable batteries. DO NOT short-circuit the supply terminals.

SQUEEZE

LARGE

TABS

SQUEEZE

LARGE

TABS

Display Unit

1. Slide off the battery

compartment cover.

2. Insert 2 x AA batteries into

the battery compartment, as