Section 1 • Overview Of Features; Section 2 • Setup; Install Batteries - ACU-RITE 825 Instruction Manual

SECTION 1 • OVERVIEW OF FEATURES
Month
& Date
Wind Gust
DST
OFF ON
WIND GUST
mph
kph
knots
Future
W
Weather
FUTURE FORECAST
Forecast
Barometric
PRESSURE
Pressure HISTORY
InHg
HPa
Barometric
Pressure
History
Wireless Temperature
& Humidity Sensor
Sends temperature and
humidity information to
the main unit
via a 433 mhz wireless
signal. This sensor
should be mounted
out of direct sunlight to
ensure accurate readings.
Powered by 2 "AA"
batteries.
Atomic
Wind Direction
Clock
Indoor
Humidity
TIME ZONE
AM
PM Temperature
PST MST CST EST
N
MAX INDOOR
MIN
NW NE
E
MAX
OUTDOOR
MIN
SW SE
Temperature
S
MIN MAX
WIND SPEED
Outdoor
mph WIND CHILL
kph
knots
HR.
Humidity
Seasonal
Wind Speed
(wind chill)
Wireless
Wind Sensor
Sends wind speed and
direction to main unit
via a 433 mhz wireless
signal. This sensor
should be mounted
high enough to accurately
record and transmit wind
information. Powered by 2
"AA" batteries.
- 2 -
SECTION 2 • SETUP
A/B/C Wireless ID Selection
To allow for more than one weather station and wireless sensor
network to be used in close proximity, the main unit and both wireless
sensors have a small switch labeled "A B C" in the battery
compartments. These switches are all factory preset into the same
position (either A, B, or C). This switch selects one of 3 wireless modes
Indoor
to use, and all 3 switches in all 3 components MUST be set in matching
positions (either A, B, or C) for wireless communication to take place
successfully. See page 11 for more details.
Outdoor

Install Batteries

Batteries must be installed into all three of the wireless sensors BEFORE
installing batteries into the main display unit. Use only fresh or new
batteries in all cases, and install correctly according to the polarity
( - & + ) symbols marked on the batteries and in the battery
compartments. We suggest using lithium batteries for better cold
weather performance. Do not mix old and new batteries.
Wireless Temperature & Humidity Sensor
INSTALL BATTERIES:
1. Remove larger
rounded solar shield.
2. Remove the battery
compartment cover.
3. Install 2 "AA"
batteries into the
battery compartment.
4. Replace the
compartment cover
and replace the solar
shield.
INSTALL
BATTERIES
REMOVE
BATTERY
DOOR
- 3 -