Advertisement
SEC TION 4 • PLACEMENT
TV
3
(.91 m)
Now that setup is complete and you understand how to operate the weather station,
you must choose a location to place the wireless sensor and the main unit. The
wireless sensor MUST be placed less than 100 feet (30 meters) away from the main
unit.
This wireless weather station uses radio frequency for communication, which is
susceptible to interference from other electronic devices and large metallic items or
thick walls. Always place both units at least 3 feet (.91 m) away from appliances ( TV,
microwave, radios, etc. ) or objects that may interfere with the wireless
communication ( large metal surfaces, thick stone walls, etc. ).
Please USE EXTREME CARE when handling the wireless sensor and the main unit. The
wireless sensor contains sensitive electronic components and a balanced
anemometer (for wind speed measurement). Care must be taken during setup and
when considering placement to make certain the unit is not dropped or struck with
any falling debris from trees or structures.
USE CAUTION when utilizing tools or equipment for mounting the wireless sensor.
Enlist the help of another individual when necessary.
Placement of Main Unit
Place the main unit in a dry area free of dirt and dust. To help ensure an
accurate indoor temperature measurement, be sure to place the main
unit out of direct sunlight, and away from any heat sources or vents in
your home. For the best atomic clock signal reception, place the main
unit with the back side facing the state of Colorado.
There are 2 placement options for the main unit. You may hang the main
unit on a wall using the integrated hang hole. Alternatively, you may
place the main unit on a table top or other flat surface using the included
detachable table top display stand.
MOUNT IN AN
OPEN AREA FOR
UN-OBSTRUCTED
WIND SPEED
MEASUREMENT
(30 meters)
- 10 -
Placement of Sensor
The wireless sensor MUST BE MOUNTED OUTDOORS to observe outdoor
temperature/humidity/wind speed and relay the information to the main unit
display. The wireless sensor must be placed less than 100 feet (30 m) from the
main unit.
The wireless sensor must be mounted securely. It is advised that the wireless
sensor be mounted well above and away from all obstructions to report the wind
speed accurately. There are three main mounting options to consider:
"FENCEPOST" OR SIMILAR MOUNTING
TIGHTEN
CLAMP
SCREWS!
INCLUDED
MOUNTING
BRACKET
SCREWS
"POLE" OR SIMILAR MOUNTING
Mount the sensor onto a 3/4" schedule 40 (25.8 mm
O.D.) pipe (not included). PVC plastic pipe is
TIGHTEN
recommended over a metallic pipe due to lower
CLAMP
risk of lightening strikes.
SCREWS!
Insert the pole completely into the bottom of the
wireless sensor. Tighten the "CLAMP" screws
securely to make certain the wireless sensor will
not fall or slide off of the pole in high winds.
INCLUDED
MOUNTING
BRACKET
Use caution when installing sensor or erecting the
NOT USED
pole. Do not install during electrical storms. Do not
place pole or sensor near electrical transmission
(POLE NOT
lines or electrical equipment.
INCLUDED)
"RAILING" OR SIMILAR MOUNTING
TIGHTEN
CLAMP
SCREWS!
SCREWS
INCLUDED
MOUNTING
BRACKET
- 11 -
Advertisement
