Mitsubishi Electric MelcoREMOTE Installation And Operation Manual page 25

3) The SIM card is located in the SIM holder which is situated on the PCB located in the lid of the unit.
If needed, remove the old SIM card, then fit the new one by sliding it into the SIM holder, in the direction of the
arrow in the following diagram:
4) Replace the lid of the unit by pressing down until it has clicked into place.
5) It may be necessary to change the MelcoREMOTE network setting after the new SIM is fitted. See the
Configuration and Commissioning chapter for more information on how to do this.
6) If not already fitted, fit the GPRS antenna. This should be located upright on a metal surface, as it has a
magnetic base.
The SIM card should be inserted such that the side with the metal contacts on are face down (i.e. not visible
when fitted).
The SIM card fitted must be GPRS enabled, contact the SIM provider to confirm this if necessary.
The SIM must not have a PIN enabled.
Ensure the antenna is screwed tightly into the MelcoREMOTE unit.
Avoid using prepay (pay as you go) SIM cards.
Page 25 of 52