Connections; Connecting To Input/Output Terminals - PIONEER DJ XDJ-RX2 Operating Instructions Manual

Connections

! Connect the power cord to a power outlet after all the connections are completed.
! Turn off this unit and disconnect the power cord from the power outlet before connecting components or changing the connections.
! Refer to the operating instructions for the components to be connected.
! Be sure to use the supplied power cord.
! Connect this unit and the computer directly using the included USB cable.

Connecting to input/output terminals

Rear panel, front panel
Headphones
Power amplifier,
powered speakers,
etc.
R L
1
Front panel
1 PHONES terminals
Connect headphones.
Stereo phone plugs (ø 6.3 mm) and stereo mini phone plugs
(ø 3.5 mm) can be used.
! Do not use the two output terminals (one for a stereo phone
jack and one for a mini-phone jack) simultaneously. If a cable is
connected to or disconnected from one of the terminals while
another terminal is in use, the volume for the terminal in use may
increase or decrease unintentionally.
2 MASTER1 terminals
Connect to a power amplifier, powered speakers, etc.
Be sure to use these as balanced outputs.
! Be careful not to accidentally insert the power cord of
another unit.
! Do not connect the terminal that can supply phantom
power.
3 MASTER2 terminals
Connect to a power amplifier, powered speakers, etc.
4 BOOTH terminals
These are output terminals for a booth monitor.
5 Kensington security slot
USB terminal
6
Connects to a computer.
! A USB hub cannot be used.
! Connect this unit and the computer directly using the included
USB cable.
10
En
Power amplifier,
powered speakers, etc.
Power amplifier
(for booth monitor)
R L
R
2 3 4 5
Rear panel
Computer
Portable audio device
DJ
software
DJ player
DJ player
L
L
L R
6 7 7 8
7 LINE/PHONO terminals
Connect a phono level (for MM cartridges) output device (analog
player, etc.) or a line level output device (DJ player, etc.).
8 AUX terminal
Connect a DJ player or a line level output component.
9 SIGNAL GND terminal
Connect a ground wire of an analog player to reduce noise that
occurs when an analog player is connected.
a MIC2 terminal
Connect a microphone.
b MIC1 terminal
Connect a microphone.
c AC IN
Connect this to a power outlet.
! Connect the power cord to a power outlet after all the connec-
tions are completed.
! Be sure to use the supplied power cord.
Analog player
Microphone
R
R L
9 a b
Microphone
To power outlet To power outlet
Power cord Power cord
c