Yamaha LST1200X1999 Service Manual page 188

Step Procedure / Part Name
ENGINE HARNESS #2
REPLACEMENT (ea.)
Battery Leads
1 Engine harness #2 to Hatch
switch harness connector
Remote control assembly
2 Neutral switch connector
3 Engine harness #2 to main
switch connector
4 Engine harness #2
Clean-out Hatch Switch
Harness Replacement (ea.)
Battery Leads
1
Hatch switch harness to engine
harness #2 connector
2
Hatch switch harness to wire lead
extension connector (from engine)
Clean-out tray
3
Hatch switch with harness
Lanyard Extension Harness
Replacement (ea.)
1 Lanyard extension harness to
main switch connectors
Remote control assembly
2 Lanyard switch to extension
harness connectors
SERVICE POINTS
NOTE:
Removal of all old harness(s) may not be possi-
ble.
ELECTRICAL SYSTEM
Qty (ea.) Service Points
Follow the "Step" order for removal.
2
1 Access: Engine compartment
1 Refer to "REMOTE CONTROL SYSTEM"
in Chapter 8
1
1 Access: Helm pod
1
2
1 Access: Engine compartment
3 Access: Engine compartment
Refer to "JET PUMP CLEAN-OUT PORTS
in Chapter 6
1
2 Access: Helm pod
Refer to "REMOTE CONTROL SYSTEM"
in Chapter 8
2
Reverse the removal steps for installation.
Secure the harness where possible in the same
method as the old harness.
Where this is not possible, secure to the old har-
ness. Cut and remove any old harness(s) that is
accessible to avoid confusion during future ser-
vicing.
23
ELEC
x
7