Cleanout Hatch Switch Inspection/Reinstallation - Yamaha LST1200X1999 Service Manual

APPLY SUPER GLUE AT THESE FLAT SIDES
CLEANOUT HATCH SWITCH
INSPECTION/REINSTALLATION
1/2" (12.5mm)
1. Open the cleanout hatch and remove the
2. Measure the set height of the switch and
3. After the switch height is set, reach through
4. Remove the top nut and pull the switch out
5. Reinstall the switch and install the top nut
NOTE: Due to Super Glue being an anaerobic-
type chemical, when used in this manner, will
require 24 hours to reach a proper cure.
CAUTION:
Do not allow any of the Super Glue into the
plunger area of the switch. If this occurs,
the switch will need to be replaced.
6. Holding the switch through the inspection
7. Repeat steps 2~6 for the other switch, then
8. Start each engine and open the hatch to
15
JET PUMP x
black inspection plug below the switches.
adjust to 1/2" (12.7mm), if necessary.
the inspection hole and pull a few inches of
the slack in the switch wiring out through
the hole. This will keep the switch from
falling down when it is removed.
through the inspection hole, being careful
not to rotate the lower nut. Apply a drop of
Super Glue (or an equivalent) to the lower
nut at each flat side of the switch. Rotate
the nut 1/4 turn, then back to its original
position to distribute the glue.
finger tight. Apply a drop of Super Glue to
the flat sides of each switch (see photo on
the left).
hole, torque the top nut to 25 in-lb. Re-
check the adjustment.
reinstall the inspection plug.
test that the engine stops and will not re-
start with the hatch open.
JET
6
PUMP