Selecting The Settings - Panasonic AW-HE100N Installation Instructions Manual

Selecting the settings

The settings described in this section are selected on the
"Pan Tilt Head Setting" menu.
1
Press the [CAM1], [CAM2], [CAM3] or
[CAM4] button to select the unit which is
to be operated.
2
Press the [MENU] button for two
seconds.
The main menu is displayed.
 HE100 menu 
Pan Tilt Head Setting
Camera Setting
3
Press the [] or [] button to make
"Pan Tilt Head Setting" blink.
4
Press the [] or [] button.
The "Pan Tilt Head Setting" sub-menu is displayed.
 Pan Tilt Head Setting 
Tally
Landing
Install Position
Smart Picture Flip
Flip Detect Angle
Controller
Initialize
Return
5
Press the [] or [] button to make the
item to be set blink.
 Hanging installation/desktop installation selection:
 Automatic picture flipping selection:
 Tilt angle at which automatic picture flipping starts:
 Tally control selection: Tally
 Landing selection:
On
Soft
Hanging
Auto
90
All
Install Position
Smart Picture Flip
Flip Detect Angle
Landing
6
Press the [] or [] button to change the
value of the item.
7
Press the [MENU] button for two
seconds.
The menu display is exited.
 Hanging installation/desktop installation selection
Using this item, change the "Install Position" setting.
Select either suspension from an overhead surface
(Hanging) or stand-alone (Desktop) as the manner in
which the unit is to be installed.
Hanging: Installation where the unit is suspended
from an overhead surface
Desktop: Stand-alone installation
 Automatic picture flipping selection
Using this item, change the "Smart Picture Flip" setting.
Select the function for flipping the picture when tilting
reaches the specified angle to ON or OFF.
Auto: The pictures are flipped.
Off: The pictures are not flipped.
 Tilt angle at which automatic picture flipping starts
Using this item, change the "Flip Detect Angle" setting.
Select the tilt angle.
 Tally lamp use selection
Using this item, change the "Tally" setting.
Set the function for having the tally lamp lighted or
extinguished by the tally control signal of the controller to
ON or OFF.
On: The function is used.
Off: The function is not used.
 Landing selection
Using this item, change the "Landing" setting.
Select "Soft" or "Just" as the landing characteristics.
Soft: Soft landing
Just: Exact landing
The level of vibration accompanying the acceleration or
deceleration initiated by the stop operation is less at the
"Soft" setting than at the "Just" (exact) setting.
1