Table of Contents
Advertisement
Parts and their functions
Wireless remote control
1 ON/STANDBY button
Each time this is pressed for two seconds, operation
switches between turning on the unit's power and
establishing the standby status.
2 Signal transmission window
3 MENU button
Each time this is pressed for two seconds, operation
switches between displaying the unit's menu and exiting
the menu.
Furthermore, the pan and tilt movement range limits
(limiters) are set and released by operating the MENU
button, PRESET/LIMIT button and the pan/tilt buttons
([], [], [] and []). For details, refer to "Setting/
releasing the limiters" (page 35).
4 CAM1 to CAM4 buttons
These are used to select the units that are to be
operated.
Once a button has been selected, the unit corresponding
to the selected button can be operated.
5 SET button
If this button is pressed for two seconds when the AWC A
memory or AWC B memory is selected by the white
balance adjustment, the black balance and white balance
are automatically adjusted and registered in the memory
currently selected.
Alternatively, if this button is pressed briefly (less than
two seconds), only the white balance is automatically
adjusted and registered in the memory currently selected.
6 MODE button
This is used to select the video signals which are output
from the unit.
Each time it is pressed, the signals are switched between
the color bar signals and camera video signals.
7 GAIN buttons [OFF] [LOW] [HI] [AUTO]
These are used to set the gain.
The gain increase can be set in three steps using the
[OFF], [LOW] and [HI] buttons.
When the [AUTO] button is pressed, the AGC function
is activated, and the gain is adjusted automatically
depending on the light quantity.
The maximum gain of the AGC function can be set using
the menu.
8 Preset memory call buttons [1] to [12]
These are used to call the information on the unit's
directions and other settings, which have been registered
in the unit's preset memories No.1 to No.1, and
reproduce those settings.
Settings in preset memories No.13 and above cannot be
called from the wireless remote control.
1
Advertisement
Table of Contents
