Cab assembly before initial start-up
Fig. 211
Turn both fastening screws (Fig. 211) at the
l
rear of the cabin in handtight.
Fig. 212
i
Note
If the bores do not match the cabin can be moved
into position by means of a crow bar (Fig. 212).
142
Fig. 213
Tighten the bottom fastening screw on the ac-
l
cess side (Fig. 213) with 578 Nm.
Fig. 214
Loosen both fastening screws (Fig. 214) at the
l
rear of the cabin again.
i
Note
The cabin will now slide into final assembly posi-
tion.
Tighten both fastening screws (Fig. 214) at the
l
rear of the cabin with 578 Nm.
BOMAG
BW 177 D-4