16
B
_ _ _ LOW SCALE VALUE FOR ANALOG OUTPUT scrolls across the display and
toggles with the currently selected low scale display value. Use the
buttons to enter your cal low position, and then press
C
_ _ _ HIGH SCALE VALUE FOR ANALOG OUTPUT scrolls across the display and
toggles with the currently selected high scale display value. Use the
buttons to enter your cal high position, and then press
D
_ _ _ CALIBRATE ANALOG OUTPUT? scrolls across the display and toggles with
SKIP. Press
your analog output.
Factory analog output calibration is precisely set before shipping this instru-
ment, and should not be adjusted unless advised by the manufacturer.
If you selected ENTER, connect a mA or volt meter across the analog
output connector (see 3.4), and then continue to 6.5E.
If you selected Skip, skip to 6.6 now.
E
_ _ _ CAL LOW ANALOG OUTPUT scrolls across and toggles with a calibration
number, displayed in internal units (mA/V). Using the
brate your low analog output as required, and press
F
_ _ _ CAL HIGH ANALOG OUTPUT scrolls across and toggles with a calibration
number, displayed in internal units (mA/V). Using the
brate your high analog output as required, and press
6.6 - Serial setup
A
_ _ _ SERIAL SETUP scrolls across the display and toggles with SKIP. If your
controller does not have a serial port installed, (or you do not wish to confi gure
your serial options now), please press
Otherwise, press the
B
_ _ _ SERIAL MODE scrolls across the display and toggles with the current serial
mode. Use the
(Modbus RTU), or RNGRA (Ranger A), and then press
TEX-BAR-MAN-15V05 (0903)
to skip, or the
button and then
and
buttons to choose between: ASCII (custom), MDBS
button and then
to skip to 6.7.
to ENTER serial setup.
Copyright © 2015 Defi ne Instruments
and
.
and
.
to ENTER and calibrate
and
buttons, cali-
.
and
buttons, cali-
.
.
Need help?
Do you have a question about the TEX-BAR and is the answer not in the manual?