Change Plate / Dish Type - Cantium Scientific MicroBio MB1 Operating Manual

Change Plate / Dish Type

The MicroBio MB1 can accommodate both 55mm / 65mm contact plates or
90mm petri dishes. The MicroBio MB1 is factory fitted with the petri dish
springs, but these can be removed and replaced with the supplied contact
plate springs (Cantium Scientific Limited part number P0001M007).
The springs for both types have
slots to allow a degree of
adjustment to suit dish / plate
manufacturer variations.
To change the spring type
remove the three screws and
springs, as highlighted by the
arrows opposite, then refit
using the same screws and the
contact plate springs. Care
must be taken not to over-
tighten or cross-thread any of
the screws.
Replacement screws are available from Cantium Scientific Limited, part
number P0001SCR003, or contact your local distributor.
17