How To Edit Routes; How To Insert Waypoints - Furuno GP-3700F Operator's Manual

9. Press the numeric keys to set the angle filtered.
10. Select [RUN CONV.]. The number of points converted to waypoints is displayed.
• WPT key: If you want to convert a filtered memory point to a waypoint, select
the memory point then press the WPT key.
• CANCEL key: If you want to convert a filtered waypoint to a memory point, se-
lect the waypoint then press the CANCEL key.
11. Push the ENTER knob to show the following message.
12. Select [RUN]. The converted waypoints are displayed on the screen. The way-
points are numbered from the youngest waypoint number among unused way-
points and displayed on the waypoints list. The converted route is displayed on
the routes list. The route number is the smallest number among the unused route
numbers.
13. Press the DISP key to close the menu.
6.2

How to Edit Routes

6.2.1

How to insert waypoints

You can newly insert waypoints to a registered route.
1. Press the MENU key to open the main menu.
2. Select [1. ROUTES/WAYPOINTS LIST].
3. Select [2. ROUTES LIST].
4. Select the route to process, and the [ROUTE NAME/ENTER COMMENT] window
appears.
5. Select [RUN] to show [RTE TRN PT LIST].
6. On the list, select where to insert the waypoint.
• Insert waypoint between existing waypoints: Put the cursor on the waypoint
which will follow the waypoint to be inserted.
• Insert waypoint at the end of route: Select first blank line.
The cursor shifts to the waypoints list.
7. Select the waypoint to insert. The waypoint is inserted at the selected location.
Note: To correct an error, press the MENU key to move the cursor to [RTE TRN
PT LIST]. Select the waypoint to remove, then press the CANCEL key.
CONVERT THE TRACK TO ROUTE.
ARE YOU SURE?
RUN CANCEL
6. ROUTES
6-5