Initial Setup - Sharp MX-2010U Technical Handy Manual

INITIAL SETUP

DEVELOPER SET-UP
Sim 25-02
Toner Installation must be performed after Auto Developer Adjustment is
completed.
**For optimum image quality & performance, it is recommended to setup &
install developer at the customer site.
Clean LSU Dust Proof Glass.
TONER INSTALLATION & REPLENISHMENT
Install CMYK Toner Cartridges.
Caution:
DO NOT open any Exterior Cover, Power OFF/ON or enter Simulation Mode
during Initial Toner Replenishment.
PRODUCT ACTIVATION & FIRMWARE UPGRADE
Activation of Optional Product(s):-
Sim 22-05
INITIAL SETUP
Sim 26-01
Sim 26-06
Sim 26-35
Sim 26-50
Sim 26-52
Sim 55-03
Sim 55-03
System Settings: Adjust Date/Time (Inc. Daylight Saving setting).
Keyboard Language Setting (For Embedded Keyboard):-
System Settings – Default Settings – Keyboard Select: Set English(US)
Network Settings – Print Port Settings: Disable WSD.
Set cassette size by adjusting the guides in the cassette.
Paper Size & Type
8
Auto Developer Adjustment - Select CMYK.
Check Firmware version(s):-
Right Tray Installation:-
Machine Destination.
Set Multi Error Counter:-
Long Paper Support (up to 1200mm):-
Non Printed Paper Counter Set-up.
Process Mixed Size Pages (orientation) when Printing in Duplex:-
SSW 3-6, 0 = Disable, 1 = Enable.
Toner Remain Status Display: SSW 22-5,
Setting:- System Settings – Paper Tray Settings.
System Settings – Product Key.
Upgrade to latest version.
Yes/No.
Set to 1 (Multi Count).
0 = Disable, 1 = Enable.
0 = Disable, 1 = Enable.
SHARP