Figure 36. Front handle installation
After you install the front handle, complete the following steps:
1. Install the compute node into the chassis (see "Install the compute node in the chassis" on page 25 ).
2. Power on the compute node.
ID label plate replacement
Use the following information to remove and install the ID label plate.
Remove the ID label plate
Use this information to remove the identification (ID) label plate from the front panel.
Before you remove the ID label plate, read
1. Read "Safety" on page iii and "Installation Guidelines" on page 21 to ensure that you work safely.
To remove the ID label plate, complete the following steps:
Watch the procedure. A video of the installation process is available:
• Youtube: https://www.youtube.com/playlist?list=PLYV5R7hVcs-B4_LYuT9X1MRWBU6UzX9gO
• Youku: http://list.youku.com/albumlist/show/id_50481482
.
Chapter 3
Hardware replacement procedures
55