Table of Contents
Advertisement
The BMC account password (1 of 12 accounts). The default value is PASSW0RD (with a
zero 0 not an O).
Note: If you do not specify any of these parameters, OneCLI will use the default values.
When the default values are used and OneCLI is unable to access the Lenovo XClarity
Controller using the online authenticated LAN access method, OneCLI will automatically
use the unauthenticated KCS access method.
Examples that do use the user ID and password default values:
onecli config set SYSTEM_PROD_DATA.SysInfoProdName <m/t_model>
onecli config set SYSTEM_PROD_DATA.SysInfoSerialNum <s/n>
onecli config set SYSTEM_PROD_DATA.SysEncloseAssetTag <asset_tag>
• Online KCS access (unauthenticated and user restricted): You do not need to specify a
value for access_method when you use this access method.
Note: The KCS access method uses the IPMI/KCS interface, which requires that the IPMI
driver be installed.
The following commands are examples of not using the user ID and password default
values:
onecli config set SYSTEM_PROD_DATA.SysInfoProdName <m/t_model>
onecli config set SYSTEM_PROD_DATA.SysInfoSerialNum <s/n>
onecli config set SYSTEM_PROD_DATA.SysEncloseAssetTag <asset_tag>
• Remote LAN access, type the command:
Note: When using the remote LAN access method to access Lenovo XClarity Controller
using the LAN from a client, the host and the bmc_external_ip address are required
parameters.
[−−bmc bmc_user_id:bmc_password@bmc_external_ip]
Where:
bmc_external_ip
The external BMC (Lenovo XClarity Controller) LAN IP address. There is no default
value. This parameter is required.
bmc_user_id
The BMC account (1 of 12 accounts). The default value is USERID.
bmc_password
The BMC account password (1 of 12 accounts). The default value is PASSW0RD (with a
zero 0 not an O).
Examples that do use the user ID and password default values:
onecli config set SYSTEM_PROD_DATA.SysInfoProdName <m/t_model> --host <bmc_ip>
onecli config set SYSTEM_PROD_DATA.SysInfoSerialNum <s/n> --host <bmc_ip>
onecli config set SYSTEM_PROD_DATA.SysEncloseAssetTag <asset_tag> --host <bmc_ip>
Step 2.
Restart the server.
Enable TPM/TCM
The server supports Trusted Platform Module (TPM), Version 1.2 or Version 2.0
Note: For customers in the People's Republic of China, TPM is not supported. However, customers in the
People's Republic of China can install a Trusted Cryptographic Module (TCM) adapter (sometimes called a
daughter card).
When a system board is replaced, you must make sure that the TPM/TCM policy is set correctly.
.
Chapter 3
Hardware replacement procedures
89
Advertisement
Table of Contents
