Port-Based Vlan - Planet FGSW-2624SF User Manual

4.3.1.1.1 Port-based VLAN

Packets can go among only members of the same VLAN group. Note all unselected ports are treated as belonging to
another single VLAN. If the port-based VLAN enabled, the VLAN-tagging is ignored.
In order for an end station to send packets to different VLANs, it itself has to be either capable of tagging packets it
sends with VLAN tags or attached to a VLAN-aware bridge that is capable of classifying and tagging the packet with
different VLAN ID based on not only default PVID but also other information about the packet, such as the protocol.
1. Click the hyperlink "VLAN Configuration" to enter the VLAN configuration interface.
2. Select "PortBased" at the VLAN Operation Mode, to enable the port-based VLAN function.
Object Description
You can configure the ID number of the VLAN by this item. This field is used to add VLANs one at a
Group ID
time. The VLAN group ID and available range is 2-4094
Port Indicate port 1 to port 26.
----------
VLAN Type
Member
3. Click to create a new VLAN group. Then the following figure appears.
4. Enter the VLAN Group ID, the available range is 2-4094.
5. Select the members for the VLAN group.
6. Click button.
7. You will see the VLAN Group displays.
FGSW-2620VM / FGSW-2624SF User's Manual
Figure 4-3-1 VLAN – PortBase interface
Forbidden ports are not included in the VLAN
Defines the interface as a Port-Based member of a VLAN.
43