Advertisement
Product Description
This exciting new J&M ROKKER XXR 2-channel 330w
fairing speaker amplifier kit has been designed specifically
for use on the 2006-2013 Harley® StreetGlide or Ultra with
the Harley HK radio.
This is a full range class D audio amplifier and is spec'd at
165watts RMS per channel X2 channels, (330w total) driven
continuous into a 2 ohm load @ 14.4vdc.
The ROKKER XXR amplifier's settings have been dialed in
& optimized for this exact speaker configuration, to provide
the maximum highway performance for your Harley bagger
audio system.
Installation Instructions
1. Remove the outer fairing shell, seat, and fuel tank.
2. By following along the factory wiring harness, route the
amplifier power harness from the fairing, under the fuel tank,
and on to the battery. (removal of the fuel tank is necessary for
proper installation)
3. After first disconnecting the negative battery cable from
the battery, connect the positive (red) lead from the amplifier
power harness directly to the positive post of the battery. Then
connect the negative (black) lead from the power harness to
the same bolt/stud on the frame that the negative battery cable
is connected to. Then reconnect the negative battery cable to
the battery. (Figure A) Do not connect the negative (black) lead
from the amplifer to the negative post of the battery.
4. For Ultra's and other models with a CB and/or a SAT Radio
installed, disconnect and remove them from the top of the
factory radio. (Figure B) Replace the factory retention screws
back into the radio. For models without a CB or SAT Radio,
continue with the next step.
5. Remove both the left and right forward radio mounting
bolts. Loosen but do not remove both the left and right
rearward mounting bolts. (Figure C)
6. Position the J&M Amp/Bracket assembly above the radio
and slide into position. (Remove tie-straps and re-position the
factory wiring harness as needed to allow the amplifier to fit
into place properly)
7. Replace the forward radio mounting bolts and then tighten
all (4) of the mounting bolts. (Figure D)
Amplifier mounts to the custom made stainless steel bracket
system, to provide solid and secure mounting inside the
Harley batwing fairing.
Custom made plug-n-play wiring harnesses are included
with this amplifier kit, top quality heavy gauge power/ground
wires are used for the fused battery connection, along with
all necessary mounting hardware & complete installation/
operation instructions.
Amplifier itself measures 7 1/4" X 4 ¾" X 1 ¾".
Fig. A
Heavy Gauge
Amplifier Power/Ground
Wire Harness
Fuse
Fig. B
Black
Master Frame
Grounding Stud
Red
Negative
Battery Cable
+
BATT
remove
Advertisement
