Advertisement
Product Overview
This is the new J&M STAGE-5 ROKKER® XXR Custom 700w
4-channel amplifier kit for 2015-2019 Harley® RoadGlide (NOT
for CVO) with the Harley 4.3 Std, 6.5GT or new GTS touch-
screen radio, with rear-lid or lower-fairing speakers added.
Full range class D amplifier, spec'd at 175watts RMS per chan-
nel X4, (700w total) into 2-ohm load @ 14.4vdc, (Manually
selectable on the amplifier itself for a 2-ohm or 4-ohm speaker
load) properly shielded against RF interference into the AM or
FM radio.
Amplifier uses advanced digital switching power supply tech-
nology to dramatically reduce the 12v current demands on the
motorcycle electrical system.
Amplifier mounts to custom made stainless steel 2-piece
bracket system, to provide solid and secure mounting inside
the fairing.
This amplifier kit is custom tuned for use in conjunction with
your specially FLASHED Harley Infotainment radio ("J&M
Corporation Custom Audio Flash" menu option w/Techno-
Research digital technician), to provide THE BEST on-highway
volume, clarity and overall performance available, from your
music source selections of FM stereo, XM sat radio, Smart-
phone or USB thumb drive.
(Harley Infotainment/BoomBox radio can also be shipped to
the J&M factory in Tucson for FLASHING, there is a separate
$75 fee for the "J&M Corporation Custom Audio" Harley radio
FLASH).
To alter these DSP settings using the internal programming
dongle already built into this new amplifier, (USB computer
connection cable included) our specific custom amplifier
programs are now available as a consumer download from the
J&M website @
https://www.jmcorp.com/static/dsp_rokker.
htm
, along with the custom Bike-Builder's-App for those who
want to fine tune their own specific amplifier adjustments.
https://www.jmcorp.com/AppRequest.asp
Custom made plug-n-play wiring harnesses are included, along
with heavy gauge power/ground wires for the fused battery
connection, all necessary mounting hardware & complete
installation/operation instructions.
Amplifier itself measures 8 1/4" Long X 5 1/8" Wide X 1 5/8"
Tall.
Installation Instructions
1. Remove the outer fairing shell, seat, and fuel tank.
2. By following along the factory wiring harness, route the
amplifier power harness from the fairing, under the fuel tank,
and on to the battery. (Removal of the fuel tank is necessary
for proper installation)
3. After first disconnecting the negative battery cable from
the battery, connect the positive (red) lead from the amplifier
power harness directly to the positive post of the battery.
Connect the negative (black) lead from the power harness
Fig. A
Heavy Gauge
Amplifier Power/
Ground Wire Harness
Fuse
to the same bolt/stud on the frame that the negative battery
cable is connected to.
Then reconnect the negative battery cable to the battery
(Figure A) Do not connect the negative (black) lead from the
amplifier to the negative post of the battery.
4. Disconnect all plugs from the rear of the radio and then
remove the radio itself by removing four mounting bolts.
(Figure B)
5. Place the amplifier into the fairing upside down with the
power/ground cable (Red and Black wires) facing towards the
left side of the bike.
6. Connect the amplifier main wiring harness to the amp
before securing to the mounting bracket. Center the amp into
position, place top bracket with J&M Logo facing up, align the
screw holes and insert three of the four supplied screws and
tighten securely. (Figure C)
Black
Master Frame
Grounding Stud
Red
Negative
+
Battery Cable
BATT
Advertisement
