Page 2
Product Description This exciting new J&M 330w BlueTooth controlled amplifier kit has Custom made heavy-duty plug-n-play wiring harnesses are all built at been designed specifically for use on the 1998-2017 Harley® RoadK- the J&M factory in Tucson for this specific application, to allow con- ing.
Page 3
Then route the forward part of this harness under the frame crossmember in front of the battery, up into the plastic wire harness holder (that runs all the way up to the fork-neck) forward all the way to a position inside the headlight housing.
Page 4
Then route the cable from the Bluetooth controller down the handlebar to the connection location inside the headlight housing and plug-in the corresponding plugs from the J&M and Harley wiring harnesses inside the headlight housing. (Photo-H) At this same time, plug-in or wire-in (depending upon year/model of your RoadKing) the switchable power source connection for the system, also inside the back of the headlight housing.
Page 5
13. Secure the wire inside the saddlebag, in position, using the pre-gummed wire/tie strap holders. Then carefully insert the wire grommet properly into the 53/64” hole so as to prevent moisture from entering the saddlebag. (Photo-L) Photo L 14. Place the left-side saddlebag on the padded bench to protect. Cut out template #4 from the instruction manual for the 2014-2017 Harley saddlebag, OR template #2 for the 1998-2013 Harley saddle- bag.
Page 6
18. Now connect all wire plugs and connections to the amplifier, us- ing the interchangeable amplifier plug harness “A” if you will be using only TWO saddlebag lid speakers, or amplifier plug harness “B” if you will be connecting 4-speakers to the system. (Photo-R) Photo R 19.
Page 7
Top Inside of Saddlebag Template 1: For 1998 - 2013 Harley Right Saddlebag - Grommet Hole Drill 53/64” Dia. Hole Cut out. (place over existing attachment rubber grommet) Top Inside of Saddlebag 13/64” Drill Template 2: For 1998 - 2013 Harley Left Saddlebag - Amplifier Plug Cut out, mark and router opening for...
WARRANTY AND REPAIR INFORMATION TWO YEAR LIMITED WARRANTY In order to facilitate the servicing of this warranty, the Warranty Registration Form should be filled out and returned within 10 days of the date of purchase. However, return of the Warranty Registration Form is not a precondition of this warranty, and this Warranty will be observed by J&M CORPORATION whether or not the Warranty Registration Form is returned, on the condition that other satisfactory evidence of the date of the original purchase is provided to J&M CORPORATION.