Advertisement
Product Description
This exciting new J&M 4-channel 500w amplifier kit has
been design specifically for use in the 2006-2011 Harley®
Street Glide with the Harley HK radio along with a second
set of speakers (4 total) mounted in the rear saddlebag or
trunk pod position.
This is a full range class G amplifier and is spec'd at
125watts RMS per channel X4 channels, (500w total) driven
continuous into a 2 ohm load @ 14.4vdc, 70watts RMS
continuous X4 channels into a 4 ohm load.
Amplifier mounts to the top of the custom made stainless
steel bracket system, which has the slots in the bottom
Installation Instructions
1. Remove the outer fairing shell, seat, and fuel tank.
2. By following along the factory wiring harness, route the
amplifier power harness from the fairing, under the fuel tank,
and on to the battery. (removal of the fuel tank is necessary for
proper installation)
3. Then route the rear speaker wiring harness along the
same path as the power harness to the rear speaker mounting
location.
4. After first disconnecting the negative battery cable from
the battery, connect the positive (red) lead from the amplifier
power harness directly to the positive post of the battery. Then
connect the negative (black) lead from the power harness to
the same bolt/stud on the frame that the negative battery cable
is connected to. Then reconnect the negative battery cable to
the battery. (Figure A) Do not connect the negative (black) lead
from the amplifier to the negative post of the battery.
5. For models with a CB and/or a SAT Radio installed,
disconnect and remove them from the top of the factory radio.
(Figure B) Replace the factory retention screws back into the
radio. For models without a CB or SAT Radio, continue with the
next step.
6. Remove both the left and right forward radio mounting
bolts. Loosen but do not remove both the left and right
rearward mounting bolts. (Figure C)
Fig. B
remove
section to properly relocate the Harley CB, XM sat radio or
iPod modules, if installed.
Custom made plug-n-play wiring harnesses are included
with this amplifier kit, top quality heavy gauge power/ground
wires are used for the fused battery connection, along with
all necessary mounting hardware & complete installation/
operation instructions.
Amplifier itself measures 10
Fig. A
Rear Speaker
Wiring Harness
Fuse
Left Rear Speaker
(Brown &
White/Brown)
Fig. C
loosen
" X 5" X 1
".
5
/
5
/
8
8
Heavy Gauge
Amplifier Power/Ground
Wire Harness
Black
Master Frame
Grounding Stud
Red
Negative
Battery Cable
+
BATT
Right Rear Speaker
(Green &
Green/Brown)
remove
Advertisement
