J&M Corporation JAMP-330HC06 Installation And Operation Instructions page 3

Fig. C
loosen
Fig. E
Amplifier
White/ Green/ Gray/
Orange White Red
Left
Factory
Speaker Harness
remove
Power Harness
Left Speaker
White/ Green/
Orange White
Orange
Green/
Black
Right
Fig. D
8. Make Amplifier/Speaker connections according to
diagram. (Figure E)
FOR ULTRA'S AND MODELS WITH A CB AND/OR SAT
RADIO, CONTINUE WITH STEPS (9) THRU (11), FOR BIKES
WITHOUT A CB OR SAT RADIO, PROCEED TO STEP (12).
9. Install the previously removed CB and/or SAT Radio
modules into the J&M lower mounting bracket and secure
using the (2) 8-32x1/4 screws provided. (these are the
Right Speaker
longer of the remaining screws) (Figure F)
10. Position the lower bracket assembly below the factory
radio and secure using the (4) remaining 8-32x3/16
screws provided. (Figure G) (Remove and re-secure any
factory wiring attached to the bottom of the radio using the
tie-straps provided)
Gray/ Green
Red /Black
11. Re-connect the CB and/or SAT Radio harness and
antenna connectors.
12. Test the system for proper operation before
reassembling the fairing, realizing that full sound quality
and fidelity will not be heard until the outer fairing shell is
completely reinstalled.
Fig. F
Orange/White
Acc. wire from
headlight harness