Yamaha YFM70RY Service Manual page 79

1. Throttle position sensor lead
2. Fast idle plunger outlet hose
3. Fuel injector lead
4. Intake air pressure sensor
5. Coolant temperature sensor lead
6. Spark plug lead
7. Rectifier/regulator
8. Headlight lead (right)
9. Reverse control cable
10. Ignition coil lead (red)
11. Ignition coil lead (orange)
12. Rectifier/regulator lead
13. Parking brake cable
14. Clutch cable
15. Rear brake light switch holder
16. Rear brake light switch lead
17. Rear brake light switch
18. Ignition coil
A. Secure the plastic band by inserting the projection
on the band into the hole in the frame, and then
fasten the leads where the throttle position sensor
lead branches off from the other leads, making
sure to point the end of the band rearward.
B. Route the leads over the fast idle plunger outlet
hose.
C. Route the fuel injector lead over the intake air
pressure sensor.
D. Route the spark plug lead to the outside of the
clutch cable and parking brake cable, making sure
that the lead does not contact the cylinder head.
E. Route the headlight lead (right) over the frame,
connect the headlight coupler, and then insert the
projection on the coupler into the hole in the stay
on the front fender bracket.
F. Route the reverse control cable to the inside of the
frame.
G. Fasten the rectifier/regulator lead to the front
fender bracket with the plastic band. Point the end
of the plastic band downward.
H. Route the rear brake light switch lead to the inside
of the spring.
I. Make sure that the rear brake light switch lead
does not contact the swingarm. There should be
no slack in the rear brake light switch lead between
the holder shown in the illustration and the holder
on the left side of the vehicle.
J. Route the rear brake light switch lead to the
outside of the rear brake light switch holder.
K. Route the parking brake cable above the clutch
cable.
L. Point the end of the plastic band downward.
2-52
CABLE ROUTING