Yamaha YFM70RY Service Manual page 168

3. Install:
• Handlebar grip "1"
M MMM M MMM M M MMM M
a. Wipe off grease or oil on the handlebar sur-
face "a" with a lacquer thinner.
b. Apply a thin coat of rubber adhesive onto the
left and right ends of the handlebar.
c. Install the handlebar grips to the handlebar so
that arrow mark "L" faces up on the left han-
dlebar grip and the arrow mark "R" faces up
on the right handlebar.
d. Wipe off any excess rubber adhesive with a
clean rag.
EWA13700
WARNING
Do not touch the handlebar grip until the rub-
ber adhesive has fully dried.
L LLL L LLL L L LLL L
4. Install:
• Left handlebar switch "1"
• Clutch lever
M MMM M M MMM M M MMM M
L LLL L L LLL L L LLL L
• Clutch lever bracket "2"
TIP
Install the clutch lever bracket as shown.
1
a. 53–54 mm (2.09–2.13 in)
5. Install:
• Brake master cylinder "1"
TIP
• Install the brake master cylinder holder with the
MMM
"UP" mark facing up.
• First, tighten the upper bolt, then the lower bolt.
6. Install:
• Spacer
• Throttle lever assembly
TIP
Fit the indentations "a" in the spacer with the
lobes "b" on the throttle lever assembly and
brake master cylinder.
LLL
4-43
HANDLEBAR
a
Brake master cylinder bracket
bolt
7 Nm (0.7 m·kg, 5.1 ft·lb)
Throttle lever holder screw
4 Nm (0.4 m·kg, 2.9 ft·lb)
2