Intel FALCON 8 Plus User Manual page 33

USER MANUAL
INTEL® FALCON™ 8+ UAS
Figure 2.13: Installing the Camera Mount
3
3
1
© 2017 Intel Corporation. All rights reserved
2
1
4
2
To install the camera mount:
1. Feed the camera mount carbon rod
into the front side of the central unit
(1). The Thumbscrew (2) is not
attached at this time. Make sure the
carbon rod is not at an angle when it
is inserted.
2. Fix the payload adapter (3).
Take care that the connector plug of
the adapter fits to the equivalent at
the front side of the UAV. See detail
#1 below.
3. On the roll servo, make sure the ball
link connector ball is fixed in the
respective slot in the adapter when
you fix the camera mount onto the
UAV. See detail # 2 below.
4. Press the releasing clip of the payload
adapter into the respective
counterpart opening at the front side
of the UAV. See detail # 3 below.
5. Install the thumbscrew nut (2) on the
back side of the central unit (Finger
tight. See detail # 4 below.
The payload adapter is the connection
between the camera mount and the cen-
tral unit of the UAV. The payload adapter
is movable when mounted on the rod of
the camera mount and is connected by a
cable.
(1) Connector plug
(2) Adapter slot for the roll servo with
ball link connector inserted
(3) Releasing clip
(4) Knurled securing nut of the actively
stabilized camera mount
33