Preparing The Remote Controller - Quad H2O SARAH2O Pro User Manual

Video feed instructions
If you are not getting a video feed via the GO app, navigate to the HD settings. Ensure the Bandwidth
Allocation is set to EXT = 80% and that the Output Device and Output Mode is set to EXT.
If you intend to fly in an area that will not provide an internet connection, be sure to first cache
the map data of your intended flight zone.
Please note that because of the component configuration used in the SARAH2O PRO the
GO app may display a camera firmware update notice, even though the camera is using the
latest firmware version. This can be ignored and will not effect the camera operation.
All other firmware upgrades should be completed as and when made available via the DJI GO
app and DJI Assistant Software.

Preparing the remote controller

Tilt the Mobile Device Holder to the desired position then adjust the antenna as shown.
1. Press the button on the side of the Mobile Device Holder to release the clamp, adjust to fit and then
attach your mobile or tablet device.
2. Connect your mobile or tablet device to the remote controller with your mobile/tablet USB charge
cable.
3. Plug one end of the cable into your mobile/tablet device, and the other end into the USB port on the
back of the remote controller.
For more information regarding the Lightbridge 2 and its features, please refer to the DJI Lightbridge 2
user manual which can be downloaded via our website:
https://www.quadh2o.com/sarah2o-pro/downloads
© 2017 QuadH2O All Rights Reserved
SARAH2O PRO User Manual
9