Camera & Gimbal - Quad H2O SARAH2O Pro User Manual

SARAH2O PRO User Manual
To adjust the clips
Hold the clip in the 'closed' position. Using the supplied 3mm hex key turn the screw clockwise, one
quarter turn at a time to increase the pressure against the dome / neoprene seal.
Repeat the water test process above until you have a watertight seal.
The dome and hatch on the aircraft use a neoprene foam seal, silicone grease and pressure to
make a watertight seal; this should be regularly checked for signs of wear or damage - for more
information please see the maintenance section on page 21.
For more information on completing the water test, please view our Quick Start Guide tutorial video
which can be viewed via our website:
https://www.quadh2o.com/sarah2o-pro/downloads
Camera and gimbal
Please note that because of the component configuration used in the SARAH2O PRO the
GO app may display a camera firmware update notice, even though the camera is using the
latest firmware version. This can be ignored and will not effect the camera operation.
Camera Profile
The on-board camera supports 4K video capture up to 4096x2160p24 and 12M pixel photos capture
by using the 1/2.3 inch CMOS sensor. You may export the video in either MOV or MP4 format for
editing. Available picture shooting modes include burst, continuous, and timer mode. A live preview of
what the camera is seeing before you shoot videos and pictures is supported through the DJI GO app.
Camera Micro-SD Card Slot
To store your photos and videos, plug in a suitable Micro-SD card
into the slot shown below before powering on the aircraft. The
camera supports up to a 64GB Micro-SD card. A UHS-1 type Micro-
SD card is recommended, because the fast read and write capability
of these cards enables you to store high-resolution video data.
Do not remove Micro-SD card from the aircraft when it is powered on.
© 2017 QuadH2O All Rights Reserved 14