HP J3102A Installation Manual page 6

HP AdvanceStack Switch
Ethernet Module
For the HP AdvanceStack Switch 2000
At A Glance
The HP AdvanceStack Switch Ethernet Module (HP J3102A) is an optional
component that you can add to an HP AdvanceStack Switch 2000 to provide
either of the following:
Four 10Base-T ports
Three 10Base-T ports and one (optional) 802.3-compatible trans-
ceiver port for other media types (such as ThinLAN, or fiber-optic)
For information on transceiver types and availability, contact your
Hewlett-Packard networking representative.
Extractor Handle
Cover Plate Over Slot for
Optional Transceiver
Figure 1.
Features:
hance your Switch 2000 in the following ways:
You can use the module to connect different 802.3 media types to
your Switch 2000.
You can add, change, or remove a module without shutting down the
entire switch.
You can install up to six Ethernet modules in your Switch 2000,
enabling you to ''fully load'' the switch with up to 24
Ethernet/IEEE 802.3 ports.
The HP AdvanceStack Switch Ethernet Module
The HP AdvanceStack Switch Ethernet Module can en-
Connector
Extractor Handle
10Base-T Ports
iii