Table of Contents
Advertisement
Installation
6. Tighten the captured screw in each handle by using a flat-blade or
Figure 5.
7. Connect the appropriate network cables to the module's 10Base-T
Figure 6.
N o t e
Use either the built-in RJ-45 connector or a transceiver for port 1—both
will not work simultaneously. The active port 1 connector is
automatically selected based on the following conditions:
6
Torx-10 screwdriver. Be careful not to overtighten the screws.
Securing the Module in the Slot
ports (and to the optional transceiver, if installed).
Connecting a Cable
If a cable carrying a link beat signal is connected to the first built-in
RJ-45 port on the module, then that port is the active port 1,
regardless of whether there is a transceiver installed.
If no link beat is detected on the first built-in RJ-45 port on the
module, then a transceiver, if installed, becomes the active port 1.
Tighten These Two Screws
Advertisement
Table of Contents
