General Transmitter Layout; Initializing The Transmitter/Battery Holder For The First Time - Napoleon GDS25N-1 Installation And Operating Instructions Manual

8.1

GENERAL TRANSMITTER LAYOUT

Transmission
Flame ON
(OPTIONAL WITH THIS MODEL)
8.2

INITIALIZING THE TRANSMITTER/BATTERY HOLDER FOR THE FIRST TIME

Install the 4 AA batteries into the Proflame 2 battery holder, note the polarity of the batteries and
A.
insert as indicated on the cover (+/-).
Ensure the 3 position slider switch is switched to the "REMOTE" position (middle position).
B.
Press the reset/programming button, use a small object such as a paper clip in order to reach the
C.
button marked PRG, as shown in the illustration below.
The battery holder will beep 3 times to indicate that it's ready to synchronize with the transmitter.
D.
Install the 3 AAA batteries into the transmitter, as shown in the photograph below, then press the ON
E.
button, The battery holder will beep 4 times to indicate that the transmitter's command is accepted.
NOTE: THE INITIALIZING PROCESS MUST BE COMPLETED WITHIN 10 SECONDS OF PRESSING THE
RESET/PROGRAM BUTTON (PRG).
BATTERY HOLDER
SLIDER SWITCH
RESET/PROGRAM
BUTTON (PRG)
Blower
Key Lock
Low battery alarm
Room
Temperature
CPI mode
LED Light
TRANSMITTER
W415-2207 / A / 08.28.17
33
EN