Handwheel Operation - Fisher 685 Instruction Manual

Instruction Manual
D103626X012
connector slightly, tightening the locknuts together, and (with the valve plug off the seat) screwing the stem either
into or out of the stem connector by means of a wrench on the locknuts.
7. If the total travel is adequate, tighten the stem connector (key 18) securely, lock the stem locknuts (if present)
against the connector, and adjust the indicator scale (key 22) on the yoke (key 21) to show valve plug position.
8. Provide a gauge, if necessary, to measure the pressure to the actuator. Make a final adjustment on the positioner to
set the starting point of valve travel and to obtain full travel for the given instrument range.

Handwheel Operation

If manual operation is required, the actuator should be equipped with a manual handwheel.
CAUTION
To avoid damage to actuator parts and difficult operation of actuator handwheels, open the bypass valve (key 66) before
using a handwheel.
The bypass assembly is furnished only when a handwheel actuator is specified. The bypass allows the pressure to
equalize on either side of the piston, so that the manual actuator can be used to position the control valve. Flow
through the bypass tubing is controlled by an angle needle valve, which is operated manually. This valve should be
closed when air pressure is being used to operate the actuator.
Key numbers referenced in the following steps are shown in figures 2 and 3. Refer to table 7 for handwheel
specifications.
1. Open the bypass valve.
2. Rotate the handwheel (key 45) to position the override engage pin (key 38) with the hole in the stem connector
(key 18). Use the engage pin control knob (key 33) to insert the override engage pin into the stem connector until it
stops. Refer to figure 2 for engage pin control knob operation.
Note
Depending on construction , the handwheel may have operation information stamped into the part. Always refer to steps 3 and 4
for operation information specific to push-down-to-close and push-down-to-open valves.
3. For a push­down­to­close valve: Rotate the handwheel (key 45) clockwise to close the valve and counterclockwise
to open the valve.
4. For a push­down­to­open valve: Rotate the handwheel (key 45) counterclockwise to close the valve and clockwise
to open the valve.
5. To disengage the manual handwheel, rotate the handwheel (key 45) to relieve any load placed on the override
engage pin (key 38), and use the engage pin control knob (key 33) to remove the override engage pin from the
stem connector (key 18). Refer to figure 2 for engage pin control knob operation.
Table 7. Handwheel Specifications
OUTPUT THRUST
ACTUATOR SIZE
N
12 44482
14 to 18 88964
20 to 26 133447
HANDWHEEL DIAMETER
lbs mm
10000 305
20000 406
30000 610
TURNS PER
TURNS PER mm
OF TRAVEL
Inch
12 3.8
16 3.0
24 2.8
685 Piston Actuator
MAXIMUM RIM FORCE
REQUIRED
INCH OF
TRAVEL
N
96 290
80 380
72 450
June 2017
lbs
65
85
100
7