ASSEMBLY INSTRUCTIONS
11. Slide the upper chute crank (A) Fig.12 into the lower chute crank (B), aligning the
screw holes.
12. Tighten the screw (A) Fig.13 into the aligned holes using a Phillips screwdriver (B).
Fasten the nut (C) with an open wrench.
13. Remove the screw (A) Fig.14 on the discharge chute base (B) with a screwdriver
(C).
14. Insert the chute crank (A) Fig.15 into the hole on the discharge chute base (B).
Insert the screw (C) previously removed and tighten it with a screwdriver (D).
ASSEMBLY
FIGURE 12
FIGURE 13
FIGURE 14
FIGURE 15