King Canada 9999 ITM Instruction Manual page 8

ASSEMBLY INSTRUCTIONS
7. Locate the three cable clips (A) Fig.8 in the parts bag. Secure the power cord to the
frame of the unit by clipping them onto the frame at evenly spaced intervals.
8. Loosen the two knobs on the chute deflector (A) Fig.9. Lift the chute deflector (A) so
that it snaps and locks securely onto the discharge chute (B).
Note: You should hear a loud click when the chute deflector (A) locks into place.
9. Raise or lower the chute deflector (A) Fig.10 to the desired height and tighten the
chute deflector knobs (B).
Note: Do not overtighten the chute deflector knobs.
10. Locate the upper chute crank (A) Fig.11 in the parts bag. Remove the screw (B)
and nut (C) from the upper chute crank (A).
ASSEMBLY
FIGURE 8
FIGURE 9
FIGURE 10
FIGURE 11