Assembly And Operation; Securing The Extension Cord - King Canada 9999 ITM Instruction Manual

ASSEMBLY INSTRUCTIONS
15. Remove the washer (A) Fig.16 and nut (B) from the eye bolt with rubber grommet
(C) found on the upper chute crank (D).
16. Position the chute crank (A) Fig.17 so that the eye bolt with rubber grommet (B)
inserts into the centre hole of the middle frame (C). Secure with washer (D) and nut (E).
Note: Do not overtighten the nut.
OPERATING INSTRUCTIONS
Note: Before using this machine, make sure that the power source you will use
complies with the specifications detailed in this manual. Before inserting the plug into
the socket, verify that the snow thrower's auger and scraper are firmly attached with
screws. Perform a test run to ensure that the rotor turns freely.

SECURING THE EXTENSION CORD

1. For safe and efficient use of your snow thrower, use only a UL-rated extension cord
recommended for outdoor use.
WARNING!
Electric shock may cause SEVERE INJURY or DEATH. Heed these warnings:
• Do not allow any part of snow thrower to make contact with water while powered on.
If the appliance becomes wet while turned off, wipe dry before starting.
• Use only a UL-rated extension cord for outdoor, all-weather use. Do not use an
extension cord more than 46 metres (150 feet) long.
• Don't touch the appliance or its plug with wet hands or while standing in water.
Wearing rubber boots offers some protection.
2. Note that the snow thrower has a polarized male plug (A) Fig. 18, with one prong in
the socket slightly longer and wider than the other. The extension cord female end
should be likewise polarized, so that the extension cord fits snugly into the socket.
3. To prevent the extension cord from disconnecting during use, lock the extension cord
in the cord retainer (A) Fig.19 as shown before connecting the tools plug to an
extension cord.
ASSEMBLY & OPERATION
FIGURE 16
FIGURE 17
FIGURE 18
FIGURE 19