King Canada 9999 ITM Instruction Manual page 7

ASSEMBLY INSTRUCTIONS
1. Hold the middle frame (A) Fig.4 so that the screw holes align with the holes on the
lower frame (B).
Note: Make sure the middle frame is held upright, positioning the middle frame in the
reverse direction will prevent proper assembly.
2. Insert the joint fixing bolt (A) Fig.5 into the aligned holes on each side. Place
washers (B) on the joint fixing bolts outside of the frame as shown.
3. Use the quick release clamps (C) Fig.5 to secure the connection.
4. Hold the upper frame (A) Fig.6 so that the screw holes align with the holes in the
middle frame (B).
5. Insert the joint fixing bolt (A) Fig.7 into the aligned holes on each side. Place
washers (B) on the joint fixing bolts outside of the frame as shown.
6. Use the quick release clamps (C) Fig.7 to secure the connection.
ASSEMBLY
FIGURE 4
FIGURE 5
FIGURE 6
FIGURE 7