Operation; Powering On And Off - King Canada 9999 ITM Instruction Manual

OPERATING INSTRUCTIONS
WARNING!
Damaged electrical cords present risk of fire, electric shock, and serious bodily injury.
Before operating the snow thrower, carefully examine the electrical cord. If the cord is
damaged, do not use the snow thrower. Replace or repair the damaged cord
immediately.

POWERING ON AND OFF

1. Insert the power switch key (A) Fig.20 into the slot on the switch housing (B).
2. To power on, first press the switch button (A) Fig.21 found alongside the switch
housing.
3. Pull the handle bar (A) Fig.22 toward you and grasp hold of it firmly with both hands
to start the machine. The machine can only be started by pressing the switch button
first, followed by squeezing the handle bar (A). Reverse operation cannot start the
machine.
4. To power off, release your grip on the handle bar (A) Fig.22
CHANGING THROW DIRECTION AND THROW HEIGHT
Warning!
Never direct the snow discharge chute at the operator, at bystanders, at vehicles or at
nearby windows. Discharged snow and foreign objects accidentally picked up by the
snow thrower can cause serious damage and personal injury.
Always orient the discharge chute in the opposite direction from where you, bystanders,
surrounding vehicles, or windows are located.
1. The discharge chute (A) Fig.23 can be adjusted 180 degrees by rotating the chute
crank (B). Rotate the chute control crank (B) clockwise to move the discharge chute (A)
to the left, counterclockwise to move the chute to the right.
2. The chute deflector (A) Fig.24 on the top of the discharge chute (B) controls the
height of the snow stream. Loosen both chute deflector knobs to raise or lower the
deflector to the desired height you wish to throw the snow. Tighten the knobs to secure
the deflector.
Note: Do not overtighten the chute deflector knobs.

OPERATION

FIGURE 20
FIGURE 21
FIGURE 22
FIGURE 23
FIGURE 23