EMS 5000 FirePoint Installation Manual page 5

Optional device locking
It is possible to lock the sensor into the wireless base. Locking is made possible by removing the cut out
section as shown in Figure 8.
Cut out section
(shaded area)
To remove the sensor once locked, insert a at blade screw driver into the lock release slot (shown in
Figure 9) and push the screw driver down into the device to release the mechanism. The sensor should
unlock and can now be removed by turning it anticlockwise.
Lock release slot
LED position
Additional locking of the wireless module into the xed mounting plate can be achieved by tting an
anti tamper screw. A 5/16 Phillips pan head screw is supplied within the packaging of each unit. To t
the anti tamper screw, the tamper knockout must be removed. The location of the tamper knockout is
shown in Figure 10.
Tamper knockout
Figure 10
MK235 Iss 4 20/12/2016 AJM
Figure 8
Figure 9