Mounting Plate - EMS 5000 FirePoint Installation Manual

Logging the device to the system
If the installation has been ordered as a complete system the devices and panel will be supplied already
"pre-programmed". The process of adding radio devices (Callpoints, Detectors, Sounders, Input / Output
Units and Transponders) to the System 5000 Control Panel, is largely carried out automatically, by the
Panel's own operating system. It is usual practice for each device to require "logging on" to the system.
In such cases, the following action must be taken.
The sounder sensor is shown below in Figure 1 and consists of three separate sections.

Mounting plate

Wireless module
Sensor
The wireless module can be programmed to the system by the following procedure:
1 - Remove the mounting plate by turning it counter clockwise.
2 - Ensure the "Logging On" function on the control panel is enabled. Refer to the 'Engineers Operating
Guide' for full details.
3 - Ensure all but one batteries are tted, leaving out the one that covers the log on button - as shown
in Figure 2.
Log on button
4 - Press the log on button for 3 seconds. The message 'Log On Default Device XXX' (Where XXX is the
device's address number on the system) will be displayed on the control panel's front display.
5 - After a short time the message 'Added Default Device XXX' will be displayed on the control panel's
front display.
6 - After approximately 10 seconds 'New Head Default Device XXX' will be displayed on the control
panel's front display.
7 - Once complete, disable the control panel's log on feature. Refer to the 'Engineers Operating Guide'
for full details.
MK235 Iss 4 20/12/2016 AJM
Figure 1
Figure 2