Microphone Complete - ReSound Pulse PS60 Technical Manual

Microphone complete

Wire, amber 12 mm
p/n 115129712
Wire, red 12 mm
p/n 15129612
Use service tool (heat zink) when soldering the microphone wires.
Brush EGC-1700 coating to the solder points and let dry for 15 sec
- then brush once more.
Wire, green 12 mm
p/n 15129812
-
+
IN
Make sure that the suspensions fit well to the
sound studs/ports on the microphones.
Make sure that wire insulation is undamaged.
Note: Make sure that the microphone is
turned right. The wires must be turned
towards the back mic suspension as
shown on the drawing.
Doc. No. 0105070 rev. C
Front mic suspension Back mic suspension
Page 19 of 30