Replacing The Fuses - Planar Clean Screen C3012T User Manual

Replacing the Fuses

Fuse (F1) Schurter 001.1014, 10A;
or Fuse (F5) Bussman GDA-10A, 10A
Figure 13
Use only the fuses specified below to prevent damage to the Clean Screen.
Fuses: F1 Schurter 001.1014, 10 A
F2 Schurter 3402.0012, 2 A
F5 Bussman GDA-10A, 10 A
1. Remove the back housing as above.
2. Using a small (jeweler type) flat screwdriver, gently pry up on the fuse.
3. To remove an F2 fuse, gently pry the metal bracket at either end and then lift the fuse out.
4. Snap in a new fuse that meets the above specifications.
Technical Note:
on your product version, you will have either an F1 or an F5, but not both.
The F1 fuse used in earlier products has been replaced by the F5. Depending
Chapter Three: Hardware Installation and Replacement
Fuse (F2) Schurter 3402.0012, 2A
11