Chapter Four: System Setup; Connecting The Keyboard; Connecting Peripherals; Pcmcia Port - Planar Clean Screen C3012T User Manual

Chapter Four: System Setup

Attach the keyboard and all peripherals before you power up the unit. All connections are made
at the bottom of the unit. If you have not yet attached the Clean Screen PC to a standard mount-
ing bracket, then lay the unit face down before you attach the keyboard and peripherals. Be sure
to use a non-abrasive cloth or other material to protect the face plate.
Power Interface
Switch or Printer Port
AT Keyboard
Connection
Figure 15

Connecting the Keyboard

Your Clean Screen can use any AT style keyboard.

Connecting Peripherals

Mouse
The Clean Screen PC uses a serial type mouse. COM A is the default.
Printer
The parallel port can be used for connecting a local printer.

PCMCIA Port

The Clean Screen allows the connection of one Type III PCMCIA Expansion Card or the use of
two Type I or Type II PCMCIA Expansion Cards.

Floppy Drive Connector

Please note that this is NOT a standard floppy drive connection. The Clean Screen is not
designed for regular use with an external floppy drive. The connector will only allow use of a
Planar 3.5" external floppy drive and is intended only for diagnostic and service use. If you need
to load drivers for your operating system or other programs, you will need to obtain the correct
drive. See What if I'm missing something? in the Before You Begin section.
Parallel
Power
Connection
Com B Floppy Drive Connector
Port (custom interface
for diagnostic or
service use only)
Headphone /
Com A Speaker Output Jack
Port (32 to 300 Ohms)
Line In PCMCIA Type III
Jack
Chapter Four: System Setup
ISA 16-bit
Expansion Slot
( 1 ⁄ card size)
2
Microphone
Expansion Port Jack
13