Pci Configuration Status And Error Messages - Planar Clean Screen C3012T User Manual

PCI Configuration Status and Error Messages

The following PCI messages are displayed as a group with bus, device, and function information.
Message
Floppy Disk Controller Resource Conflict
NVRAM Checksum Error,
NVRAM Cleared
NVRAM Cleared By Jumper
NVRAM Data Invalid, NVRAM Cleared
Parallel Port Resource Conflict
PCI Error Log is Full
PCI I/O Port Conflict
PCI IRQ Conflict
PCI Memory Conflict
Primary Boot Device Not Found
Primary IDE Controller Resource Conflict
Primary Input Device Not Found
Secondary IDE Controller Resource Conflict
Serial Port 1 Resource Conflict
Serial Port 2 Resource Conflict
Static Device Resource Conflict
Device Resource Conflict
Explanation
The floppy disk controller has requested a
resource that is already in use.
The ESCD data was reinitialized because of an
NVRAM checksum error. Rerun the ICU.
The Clear CMOS DIP switch has been moved
to the ON position and CMOS RAM has been
cleared.
Invalid entry in the ESCD.
The parallel port has requested a resource that
is already in use.
This message is displayed when more than 15
PCI conflict errors are detected. No additional
PCI errors can be logged.
Two devices requested the same resource,
resulting in a conflict.
Two devices requested the same resource,
resulting in a conflict.
Two devices requested the same resource,
resulting in a conflict.
The designated primary boot device (hard disk
drive, diskette drive, or CD-ROM drive) could
not be found.
The primary IDE controller has requested a
resource that is already in use.
The designated primary input device (key-
board, mouse, or other, if input is redirected)
could not be found.
The secondary IDE controller has requested a
resource that is already in use.
Serial port 1 has requested a resource that is
already in use.
Serial port 1 has requested a resource that is
already in use.
A non-plug-and-play ISA card has requested a
resource that is already in use.
A non-plug-and-play ISA card has requested a
resource that is already in use.
Appendix C: Troubleshooting
45