Refrigerator Operation; Cleaning; Maintenance - Dometic RML 8330 UL Operating Instructions Manual

For mobile home or recreational vehicle installation. operation by lp gas, 12v dc or 120v ac
Table of Contents

Advertisement

Available languages

Available languages

4.0 Refrigerator operation

The refrigerator is equipped to operate on
three power modes:
Mains voltage (120V AC)
Direct-current voltage (12V DC)
Gas (propane)
Select the desired power mode by the energy
selector switch .
4.1

Cleaning

Before starting up the refrigerator, it is recom-
mended that you clean it inside and repeat this
at regular intervals.
Use a soft cloth and lukewarm water with a
mild detergent. Then wipe out the appliance
with clean water and dry thoroughly.
To avoid material alterations, do not use soap
or hard, abrasive or soda-based cleaning
agents. Do not allow the door seal to come
into contact with oil or grease.
4.2
We recommend maintenance following an
extended shutdown of the vehicle. Please
contact our customer services.
NOTE: Avoid spraying water through the
vent grilles when washing the RV.
It is important to keep the refrigerator vent
area free from combustible material, gasoline
Fig. 4
and other flammable vapors or liquids.
13
Refrigerator operation

Maintenance

It is recommended that the gas burner be
inspected and cleaned as necessary at
least once a year. When using liquefied
petroleum gas (tank or refill cylinders) the
maintenance interval is reduced. Keep the
evidence of maintenance work carried out
on your refrigerator.
Work on gas and electrical equipment
shall be carried out by qualified person-
nel only. It is recommended to have it
done by an authorized customer ser-
vices department.
The gas burner must be inspected and
cleaned as necessary at least once a
year. When using liquefied petroleum gas
(tank or refill cylinders) the maintenance
interval is reduced to half-yearly or quar-
terly.
Keep the evidence of maintenance work
carried out on your refrigerator.
Check all connections in the LP gas system
(at the back of the refrigerator) for gas
leaks. The LP gas supply must be turned
on. Apply a noncorrosive bubble solution to
all LP gas connections. The appearance of
bubbles indicates a leak and should be
repaired immediately by a qualified service-
man who is familiar with LP gas systems
and refrigerators.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents