Processor Unit - Furuno FAR-3230S(-BB) Installation Manual

2. WIRING
2.3

Processor Unit

Note: The interface ports approved for interconnecting navigation equipment are
shown in the figure below. For details, see paragraph 2.3.3 "How to select the serial
input/output format".
Top view of EC-3000
2.3.1 How to connect cables to terminals in the processor unit
Use screws (M3×6, supplied) to attach the wiring plate 1 and wiring plate 2 to the pro-
cessor unit. Connect the cables shown below to the connectors at the front of the pro-
cessor unit. Bind cables to the appropriate fixing metal with the cable ties (supplied).
For the cables from the monitor unit (type: DVI-D/D SLINK5M/10M* (*: MU-190 only),
DSUB9P-X2-L5/10M) and ground wire, connect them to the processor unit directly
(without fixing to a wiring plate). Tighten the fixing screws on these connectors to pre-
vent disconnection from the processor unit.
Note: Connect the cables so that they do not interfere with the opening or closing of
the DVD tray.
OK
Desktop or Bulkhead (Sideway slot)
2-10
J8 J8 J8
J5 J5 J5
J3 J3 J3
J12 J12 J12
J11 J11 J11 J6 J6 J6 J9 J9 J9
J4 J4 J4
J13 J13 J13
J10 J10 J10
J7 J7 J7
UP
Hanging or Bulkhead (Vertical slot)
J3, J4
For IEC 61162-2 or
IEC 61162-1
J14 J14 J14
J5, J6, J7, J8, J9, J10
For IEC 61162-1